Waeco CoolMatic HDC195, Installation And Operating Manualon And Operating Manualing Manual

Page: 41 / 388

EN
HDC195, HDC225 Safety instructions
41

The refrigerator is not suitable for transporting substances
which are caustic or contain solvents.
 Keep the drainage outlet clean at all times.

Do not open the refrigerant circuit under any circumstances.
 Never transport the device in a horizontal position, so that no oil
can leak out of the compressor.
 Make sure that the refrigerator circuit is not damaged during
transportation. The refrigerant in the refrigerator circuit is highly
flammable.
In the event of any damage to the refrigerator circuit:
– Avoid naked flames and sparks.
– Air the room well.
 Set up the device in a dry location where it is protected against
splashing water.
2.2 Operating the device safely
D
DANGER!
 Do not touch exposed cables with your bare hands.
!
CAUTION!
 Before starting the device, ensure that the power supply line
and the plug are dry.
 If you connect the device to a battery, make sure that no food
comes into contact with the battery acid.
A
NOTICE!
 Do not use electrical devices inside the cooling device unless
they are recommended by the manufacturer for that purpose.
 Do not place it near naked flames or other heat sources
(heaters, direct sunlight, gas ovens etc.)
 Danger of overheating!
Always ensure sufficient ventilation so that the heat generated
during operation can dissipate. Make sure that the device is
sufficiently far away from walls and other objects so that the air
can circulate.
 Ensure that the ventilation vents are not covered.
 Do not fill the inner container with ice or fluid.