CoolMatic CRP-40
Safety instructions
25
I
Note
Supplementary information for operating the device.
➤
Action:
This symbol indicates that action is required on your part. The re-
quired action is described step-by-step.
✓
This symbol describes the result of an action.
fig.
3
1, page 4:
This refers to an element in an illustration. In this case,
“item 1 in figure
fig.
3
on page 3”.
Please also observe the following safety instructions.
2
Safety instructions
WAECO International will not be held liable for claims for damage resulting
from the following:
z
Damage to the device resulting from mechanical influences and excess
voltage
z
Alterations to the device made without the explicit permission of WAECO
International
z
Use for purposes other than those described in the operating manual
2.1
General safety
a
z
Have a trained technician perform the installation in wet rooms.
z
Do not operate the appliance if it is visibly damaged.
z
This appliance may only be repaired by qualified personnel. In-
adequate repairs can cause considerable hazards.
If you device should need repairing, please contact WAECO
customer service.
z
Do not open the refrigerant circuit under any circumstances.
z
Set up the appliance in a dry location where it is protected
against splashing water.
z
Do not place it near naked flames or other heat sources (heat-
ers, direct sunlight, gas ovens etc.).
z
Ensure that the ventilation slots are not covered.
z
The appliance is not suitable for the storage of caustic materials
or materials containing solvents.
z
For use only on vessels over 20 meters in lenght.
CRP-40.book Seite 25 Donnerstag, 8. Oktober 2009 11:48 11
