Changing the Decor Panel
- Repair Guide
1. Remove the seal from the top of the door
4. Pull the standard décor panel out
and replace with your desired panel
5. Reverse steps 4 to 1
3. Pull the handle up and out. The section is in a
T shape
2. Locate and unscrew the four screws across
the top
Repair Guides
Replacing the electronic module
1 Locate the module at the rear.
2 Isolate the supply.
Remove the other female crimps.
Make a note of the wiring.
3 Remove the screw which is in between.
The module will hinge away from the
compressor. Pull off the 3 pin plug
The CR range has a wiring
diagram on the side of
the fridge case.
Please note:
when working on the fridge you must isolate and disconnect the supply!
www.dometic-waeco.com • [email protected]
Page 5
