Waeco CoolAir CA-1000-AC, Installation And Operating Manual

Page: 42 / 220

Installation
CoolAir
42
5.3.4 Menu level 3: Operating mode
The system always starts with a defined operating mode for room
temperature. This parameter can be configured:
➤
Start configuration mode (see chapter "Start and end configuration
mode" on page 40).
✓
The first digit of the display (see fig. 15 on page 7, 5) shows the menu
level and the second and third show the parameter which can be set.
➤ Press the + button (see fig. 15 on page 7, 6) twice to switch to menu
level 3 .
➤ Press the Mode button (see fig. 15 on page 7, 4) to change the
parameter.
✓ The digits in the display flash until the parameter you enter is
confirmed.
➤ Use the + and - buttons (see fig. 15 on page 7, 6 and 7) to select the
mode the system starts in (e.g.
00
for automatic mode or
01
for mode 1 etc.).
➤
Press the Mode button (see fig. 15 on page 7, 4) to confirm your
entry.
✓
The set value is saved and is then used when the system is restarted.
✓
You are now in menu level 3 and can use the + and - buttons to switch
between menu levels.
5.3.5 Menu level 4: Space factor
The space factor (03 to 20) affects the power levels of the compressor and
fan in automatic mode. If the space to be cooled is very large, select a
higher space factor:
➤ Start configuration mode (see chapter "Start and end configuration
mode" on page 40).
✓ The first digit of the display (see fig. 15 on page 7, 5) shows the menu
level and the second and third show the parameter which can be set.
➤ Press the + button (see fig. 15 on page 7, 6) three times to switch to
menu level 4 .
➤
Press the Mode button (see fig. 15 on page 7, 4) to change the
parameter.
✓
The digits in the display flash until the parameter you enter is
confirmed.
➤
Use the + and - buttons (see fig. 15 on page 7, 6 and 7) to select the
temperature (in °C) with which the system starts.
➤
Press the Mode button (see fig. 15 on page 7, 4) to confirm your
entry.
_CA-1000.book Seite 42 Freitag, 28. Juli 2006 10:35 10