10
11
Venturi Effect
The air outlet has been designed
to multiply the air flow provided by
the engine. The additional airflow is
produced, without using more energy,
by the vacuum effect.
Instructions of use
The temperature for each mode is: FAST 95
degrees, CARE 75 degrees, SCALP 55 degrees
and BABY 45 degrees. With the FAST mode,
if you use the small nozzle, you reach 105
degrees, if you use the big one you reach
95 degrees and 85 degrees if you use the
diffuser. When using the modes BABY, SCALP,
CARE or FAST, you will be able to adjust
speed level but the temperature will always be
the one that is set up for this mode.
NOTE: temperature can only be adjusted in the MANUAL mode.
Press the speed switch to increase it. The dryer will adjust
the speed into levels 1, 2 or 3. If you keep pressing the switch
once you have reached the highest level, the speed will start
to lower into 3, 2, 1 in this order. When you reach again the first
level, a blue light will turn on, when you reach the second level
there will be two lights and three if you reach the third level.
Press the cold air switch and the device will switch into cold
air mode. You will see on the display the snow symbol and the
temperature symbol will disappear. If you press again the cold
air, the snow symbol will disappear from the display and the
temperature symbol will appear again. You can switch it into
cold air mode at any mode or temperature you are using.
Press the temperature switch to increase it from 0 to 1, 2, 3
or 4. When the temperature is at the highest level, press the
switch to decrease it up to 3, 2, 1, 0.
8
10
9
Self-cleaning function
Plug the turned-off device into the power supply and press the lower side of the temperature switch and the lower side of the speed switch
at the same time during 3 seconds and the device will start the self-cleaning function. This mode works with the motor in reverse at highest
speed during 10 seconds. After this time, you can activate it again if it is necessary.
During the daily operation, the products, the hairspray and the suspended particles get the filter dirty. The upmarket performances as well
as its lifespan may be seriously affected if the filter is not clean enough. You need to daily clean the filter and the air input sponge and also
activate the self-cleaning function. Prevent any substance from entering the device during the filter cleaning process.
Note: the self-cleaning function works three times when the dryer is plugged or when it starts working.
VERY IMPORTANT: The air filter needs to be cleaned so that the hair dryer works properly and its lifespan is not reduced. If it is a
brushless motor, as it is the case, the filter cleaning is completely essential.