Page 40
USING THE LENS CURSOR
The Intuos2 Lens Cursor is an input device that allows you to enter precise coordinate position information
into your computer. The Lens Cursor reports the position of the cross-hair to the computer. This makes
the Lens Cursor especially useful for tracing and digitizing drawings into graphics and CAD applications.
By default, the Lens Cursor is set to M
OUSE
M
ODE
, which means you can position the screen cursor like
you do with a regular mouse. When using the Lens Cursor to digitize a drawing, the Lens Cursor must be
set to P
EN
M
ODE
.
Refer to
Customizing the 4D Mouse and Lens Cursor
for information on programming the Lens Cursor
buttons.
Left-Click Button
Middle-Click Button
Right-Click Button
Rotate lens for best viewing angle.
Rear Buttons (defaults are left double-click)
Important: When the Lens Cursor is not in use,
place it on your desk. Leaving an Intuos2 tool
on the tablet may interfere with screen cursor
positioning when using other pointing devices.
