9
9
Battery and power management
This section contains important information about the battery and power management features of the
Graphire Bluetooth pen tablet. Be sure to review the following items:
Installing the battery
Charging the battery
Power saving features
Power indicator light
See also
for more information about tablet features.
Installing the battery
Your wireless pen tablet uses a rechargeable Lithium Polymer (Li-Poly) battery as the power source for
mobile operation, and a power adapter for charging the battery and to operate the tablet using outlet power.
Before installing or working with Graphire Bluetooth, you must first install the rechargeable battery that came
with your tablet.
To install the tablet battery:
1. Turn the wireless tablet upside down and slide open the battery compartment door (see picture below).
2. Align the notch on the battery cable plug with the cutout in the tablet connector, then press the plug into
the connector as shown.
3. Insert the battery into the battery compartment and close the compartment door. Move on to
Important:
Use only the correct battery provided
by Wacom and be careful not to drop it on hard
surfaces. The battery can be damaged internally
when dropped, and should be replaced even if
there is no obvious damage. This will help
prevent any future damage that could occur to
the tablet if the battery has been dropped, is
installed in the tablet, and then later develops a
short or leak while in the tablet.
Warnings:
Do not attempt to install the battery backwards or
reverse the polarity. If you do so, you may
damage the tablet, cause a fire, or personal injury
may result.
NEVER attempt to use other battery types in your
tablet. Doing so may damage the tablet, cause a
fire, or personal injury may result.
for additional
battery cautions and warnings.
