Wacker Neuson PS3 1500, Operator'S Manual, Page: 19 / 52

PS3 1500 / PS3 2200 Installation
wc_tx001974gb.fm
19
3.7.4 Remove the plastic cover (not shown) from the front face of the
terminal box. Using a screwdriver, detach and move the lead wires as
needed to configure the operating voltage.
3.7.5 Reinstall the plastic cover.
3.7.6 Make sure that the O-ring (w) and gasket (x) are properly seated.
NOTICE: Replace the O-ring or gasket if either shows signs of damage or
wear.
3.7.7 Lower the housing cover onto the motor bracket. Align the housing
cover as shown.
3.7.8 Fasten the housing cover to the motor bracket.
Result
The operating voltage of the motor has now been changed.
Desired
voltage
Terminal block Wire locations
110V Upper L2 and T2 together at position 2 (from left)
Lower T1 and T3 together at position 3 (from left)
220V Upper T2 at position 5 (from left)
Lower T1 at position 4 (from left)
T3 at position 5 (from left)