Wacker Neuson PS2A 800, Operator'S Manual

Page: 26 / 58

wc_tx001646gb_FM10.fm
26
Maintenance PS2 800 / PSA2 800
5.2 Maintenance and Inspection
Regular maintenance and inspections are a necessity for continued efficient
functioning of the pump. If any abnormal conditions are noticed, refer to the
Troubleshooting section and take corrective measures immediately. It is
recommended that a spare pump be kept ready in case of any problems.
Washing the
pump
Remove accumulated matter from the surface of the pump and wash it with clean
water. Take special care to remove any debris from the impeller.
Inspecting the
pump exterior
Look for any peeling or chipped paint, and make sure the nuts and bolts are
fastened tightly. Any cracks in the surface should be repaired by cleaning that area,
drying it and then applying a touch-up coating.
Note: Touch-up paint is not supplied. Note that some kinds of damage or
looseness may require that the unit be disassembled for repairs. Please consult
your nearest dealer or Wacker Neuson representative.
5.3 Storage
When the pump is out of use for an extended period, wash it and dry it thoroughly,
then store it indoors.
Note: Always run a test operation before putting the pump back into service.
If the pump is left in the water, it should be run a minimum of once a week.
WARNING
Personal injury hazard from electrical shock or unexpected starting of the pump
motor.
► Before inspecting the pump, make certain the power supply (circuit breaker,
etc.) is turned off. Then unplug the cable assembly from the receptacle or
detach it from the terminals.