Operation
GS 12Ai
2
9
wc_tx001589gb.fm
4.7
Control Panel
The generator is protected by a 16 amp circuit breaker
(a)
located on
the control panel.
The circuit breaker protects the generator from severe overloads or
short circuits. If the circuit breaker opens, turn the engine off
immediately and determine the cause before restarting. Check the
appliances and tools attached to the generator for defects and make
sure their power requirements do not exceed the power rating of the
generator or the current limit of the receptacles.
When the circuit breaker opens, the breaker lever will snap down. To
reset circuit breaker, lift lever up.
The generator has following type of receptacles:
•
One 250 volt, IP54
(c)
•
One 250 volt, large flange, IP54
(e)
•
one 230 volt, IP44 CEE
(d)
•
one 400 volt, 3-phase 5 pin receptacle IP44 CEE
(b)
wc_gr007686
a
c
d
e
b
