Wacker Neuson EH 9 BL/230, Operator'S Manual, Page: 12 / 24

Description
T00755GB.fm
10
4.3.2 Lock button
Lock control lever by means of lock button when using the hammer for
long breaking operations. When pression on control tongue, lock
button is released.
4.3.3 Handle system at tool holder (consisting of two handle pieces)
∗
Offset handle
Than handle can be turned perpendicularly to the tool shaft direction
and according to the application requirements by approx. 270
o
.
Loosen the adjusting ring for turning of handle. The handle can be
adjusted in 22,5
o
steps by tightening the adjusting ring.
∗
Radial handle
This handle can be screwed into either the additional handle or at the
side of the housing.
4.3.4 The complete handle system can additionally be turned by 360
o
,
perpendicularly to the tool shaft direction. It must be tightened with the
SW13 hex of the radial handle before starting any application (approx.
14 Nm).
4.4 Disassembly
4.4.1 Tool holder/Cylinder housing
emove pin. Remove supplementary handle with holder spring from tool
holder. Remove cheese head screws. Remove tool holder, tool holder
bush and damping sleeve. Remove cylinder housing from crankcase.
Remove percussion piston.