5 Setup and function
100_0202_sf_0010.fm
17
In order for the machine to be able to execute the control commands, the remote control and machine
must be set to the same transmission channel.
Each machine has its own address for the transmission channel. Upon delivery, the transmitter unit is
set to the address of the machine and will only work with this machine. If the transmitter unit operates
another machine, this can be adjusted, see
Setting the transmission channel (remote control)
chapter.
Receiving area
Operation is only possible when the machine is within the receiving area. The receiving area is
approximately 20 meters from a receiving unit of the machine.
Within the receiving area, there must always be a clear line of sight between the remote control and the
machine. If there is no clear line of sight, the machine will cease all vibration and movement.
Outside of the receiving area, the machine will not receive the commands. The machine will stop
vibrating and moving.
Proximity area
If the machine comes within 1–2 meters (proximity area) of the operator, it will cease all vibration and
movement. Once the operator leaves the proximity area, the machine is once again able to receive
commands.
If the operator is laterally closer than 1–2 m from the machine or if the infrared signals of the remote
control are transmitted via reflection, a stopping of the vibration and movement is not guaranteed.
If another person comes within 1–2 meters (proximity area) of the machine, the machine will not cease
vibration and movement. The shutdown in the proximity area only works in conjunction with the remote
control unit.
5.3.2
Diagnostic system
The diagnostic system of the machine consists of control electronics and sensors that monitor various
components of the machine.
If the diagnostic system detects a fault or an error, this is signaled to the receiving unit by solid or flashing
red lights. A fault indication with error code appears on the display.
Each error code stands for a specific fault. The diagnostic system can distinguish between approx. 30
error codes.
In case of serious faults, the error code is entered into the error memory, and the machine will
automatically switch off the motor or deactivate itself.
Item
Designation
Item
Designation
1
Receiver unit (front, rear)
3
Receiving area
2
Proximity area
1
2
2
3
3
Summary of Contents for DPU80 Series
Page 74: ......
