Wacker Neuson BTS 930, Operator'S Manual

Page: 48 / 62

T00823GB
46
Instructions for periodic maintenance
To ensure long life, prevent damage and ensure the full functioning of the safety features the following main-
tenance must be performed regularly. Guarantee claims can be recognized only if this work is performed reg-
ularly and properly. Failure to perform the prescribed maintenance work can lead to accidents!
Users of the Power Cut must not perform any maintenance work not described in this Instruction Manual. All
such work must be carried out by a WACKER service station.
General Entire Power Cut Clean exterior, check for damage. In case of damage, have
repaired by a qualified service centre immediately
Cutting disc Inspect regularly for damage and wear.
Protection hood Clean.
Before each
start Cutting disc Inspect for damage and make sure the cutting wheel is right for
the job.
V-belt Check V-belt tension.
Combination switch,
Safety locking button,
Throttle lever Functional check.
Fuel tank plug Check for tightness.
Every day Air filter Clean.
Idle speed Check (cutting disc must not turn on idle).
Every week Fan housing Clean to ensure proper air cooling.
Starter cable Check for damage.
V-belt Check V-belt tension, inspect for damage and wear.
Paper cartridge Clean.
Spark plug Check and replace if necessary.
Muffler Check tightness of mounting.
Every 3
months Suction head Replace.
Fuel tank Clean.
Storage Entire Power Cut Clean exterior, check for damage. In case of damage, have
repaired by a qualified service centre immediately
Cutting disc Remove and clean.
Fuel tank Empty and clean.
Carburetor Run empty.