Operation
BFS 614B
wpm_tx001178gb.fm
20
DO NOT cut into the crushed stone layer or similar material layer when
working with a diamond blade. Uneven wear may occur when cutting
along road edges or two different types of materials (cutting along
joints). Special care is required if the material to be cut shows
irregularities (eg. reinforcement bars). This could easily lead to an
overloading of the cutting blade. Proceed carefully when starting a cut.
Lower the blade into the material slowly.
CAUTION: Special care is required when working on slopes (lanes and
surfaces). Make sure the machine is not exerting a lateral pressure on
the blade.
3.7.2
Installation of Cutting Blade:
See Graphic: wpmgr006728
3.7.2.1
Make sure that the engine is switched "OFF".
3.7.2.2
Turn the crank
(a)
counter-clockwise until the machine tilts
up at maximum height.
3.7.2.3
Fold up blade-guard
(b)
from the front side.
3.7.2.4
Using the wrench that comes with the machine, remove the
screw
(c)
which fastens the face-plate
(d)
.
3.7.2.5
Take out the face-plate
(d)
, and then place the blade
(e)
through the shaft next to the supporting disc
(f)
.
3.7.2.6
Then re-install the face-plate
(d)
and secure by tightening
the screw
(c)
.
3.7.2.7
Fold down the cutting blade guard
(b)
.
a
b
c
d
e
f
wpmgr006728