17
Revision 03/05/07
BFS SERIES
Operation
5. Saw Operations
This section of the manual describes the operating procedures, and
safety precautions for proper use of this concrete saw. This saw is
intended for industrial applications by experienced operators. It is to
be operated in conformance with applicable federal, state and local
codes or regulations pertaining to safety, air pollution, noise, etc.
Improper use of this equipment, or improper machine alterations may be
dangerous. It is the operator’s responsibility to use this machine under
safe working conditions and to be fully aware of requirements for operator
safety. The operator must be aware of the machine’s capabilities and
limitations and follow the safety precautions in each section of this manual.
5.1 Description of Controls
All controls for saw operation are located on the console.
The raise/lower lever wheel raises the blade when rotated clockwise and
lowers the blade when rotated counterclockwise.
The raise/lower wheel lock is engaged when the knob on the right
side of the console is tightened.
The throttle control increases engine rpm from slow (idle) at the
bottom, to fast (full rpm) at the top.
The forward/reverse speed control gradually increases the saw travel
speed (up to forward, down for reverse) when moved from the central
neutral position. Always place this control in neutral before using the
engage/disengage lever or starting or stopping the engine
The transmission engage/disengage lever is engaged in the full
down position.
The keyed ignition switch turns clockwise to the ON and START
positions. The engine turns over with the switch in the START
position. Release the key after the engine starts.
WARNING
5.1.1
5.1.2
5.1.3
5.1.4
5.1.5
5.1.6
raise/lower control wheel
rpm/hour gauge
trans.
control lever
throttle
hose bibb
depth gauge
water control lever
trans. engage/disengage lever
choke
on/off switch
optional pump
on/off switch
