Wacker Neuson 5200019694, Operator'S Manual

Page: 21 / 44

wc_tx003931gb_FM10.fm
21
PG1 Operation
3.8 Starting, Operating, and Stopping the Machine
Requirements
■
Suction and discharge hoses properly attached and positioned
■
There is fuel in the tank
■
Machine is primed
Starting the
machine Perform the procedure below to start the machine.
1. Set the throttle lever (a) to the low speed position.
2. Set the stop switch to the “ON” position (b) .
3. Close the choke lever (c) .
■
If the engine is cold or the temperature is low, set the choke lever to the
CLOSED position
(c
1
) .
■
If the engine is hot or the temperature is high, set the choke lever to the
OPEN position
(c
2
) .
4. Push the primer button (d) 7 to 10 times.
5. Pull the starter grip (e) lightly until you feel resistance, then pull briskly. Repeat
until the engine starts.
Note: Do not pull the starter rope out all the way.
This procedure continues on the next page.
ON
OFF
a
b
c
d
c
1
c
2
e