F-094L
12
l
Hanger Bal
n
Pi
d
Downro
Set Screw
1. Remove the hanger ball portion from the
downrod/ hanger ball assembly by loosening
the set screw in the hanger ball until the ball falls
freely down the downrod. Remove the pin from
the downrod, then remove the hanger ball. Retain
the pin and hanger ball for reinstallation (Fig 4).
2. Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation (Fig. 5).
3. Loosen the two set screws in the downrod
support of the motor assembly. Route the blue/
white, red, gray, yellow wires and safety cable
through the downrod (Fig. 6).
4. Thread downrod into the collar on top of the motor.
Install the clevis pin by aligning the holes in the
downrod support with holes in the downrod. Secure
clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. (Fig. 7)
5. Slip the coupling cover, canopy screw cover
(painted side face down), and canopy (opened
side up) onto the downrod. Coupling cover goes
all the way to the bottom. (Fig. 8)
Black/White, Blue,
Red, Gray, Yellow
wires and safety cable
Downrod
Set Screws (2)
d
Downro
Hairpin Clip
)
Locking Nuts (2
Set Screws and
n
Clevis Pi
4
6
5
7
n
Clevis Pi
Hairpin Clip
Cross Pin
Blue/white, red,
gray, yellow wires
and safety cable
6. Carefully reinstall the hanger ball onto the downrod,
being sure that the cross pin is in the correct position,
the setscrew is tightened and wires are not twisted. A
loose set screw could create fan wobble.
07
HANGING THE FAN
