13
F-068 / F-068L
Assemble upper housing to motor assembly using the
6 screws provided
(FIG. 8).
1.
Take out the screw located in the hanger ball, lower the hanger ball
and remove the cross pin. Remove the hanger ball from the hanger
ball/downrod assembly.
2.
Remove the clevis pin and cotter pin and loosen the two collar screws
from the motor collar.
3.
Feed motor wires and safety cable through coupling cover, canopy
ring, and canopy.
4.
Carefully feed the motor wires and safety cable up through the
downrod. Thread the downrod assembly onto motor collar.
5.
Align the holes of the downrod and collar and insert the cotter pin and
clevis pin. Tighten the two collar screws.
6.
Slip the coupling cover, canopy screw ring (painted side down), and
canopy (opened side up) onto the downrod.
7.
Reinstall the hanger ball onto the downrod, being sure that the cross
pin is in the correct position and the screw is tightened.
WARNING:
Failure to properly install the cotter pin and/or tighten the set
screws could result in the fan loosening and possibly falling. Take special
care to make sure the cotter pin is reattached.
NOTE:
Make sure all screws are tightened and that wires are not twisted.
FIG.8
Cross Pin
Hanger Ball
Downrod
Set Screw
0
8
HANGING THE FAN
