WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. DeCember 9, 2022 10:33 Am
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
3
Main Breaker
The main breaker will cut power to both the transformer electronics and the fixtures.
Zone Selection
A short tap on the button will activate the selected zone for control. The LED to the right of the zone name will illuminate to indicate that the
zone has been selected.
For Zone 1, to change the zone from Smart Mode to Legacy Mode, press and hold the “Zone 1” button for 6 seconds. The color of the indicator
LED will change indicating that you’ve changed modes as shown below
Smart Mode – Green LED
Legacy Mode – Red LED
Zone Control
Once a zone has been selected, you can use the Zone Control Buttons to adjust all fixtures on that zone. For Smart Mode zones, all fixtures in
connected to the zone will change. For more granular control, use the [whatever we call the app].
The color being output on the fixtures will be shown on the output indicators.
Reset Operations
Factory Reset – Press and hold the reset button for 10 seconds. The System status indicator will flash 5 times indicating the system has been
reset to its factory settings.
NOTE:
All information for this transformer including fixture names, groups, schedules, automations, etc will be erased. This is an irreversible
operation.
Network Reset – Press the reset button 5 times quickly. The Network Status Indicator will flash 5 times indicating that the network subsystem
has been reset. The system will then be ready for connection to another network via the [whatever we’re calling the app]. If the transformer is
connected to the network via Ethernet it will reconnect and re-establish its connection to the cloud. NOTE: This operation will not remove the
transformer from your cloud account and is intended only for use in changing Wi-Fi networks.
DMX Integration
Your Colorscaping Smart Transformer supports integrations with control systems via DMX512A. The standard pinout specified in the DMX512A
standard is supported. If this is the last/only node on a DMX bus, you must install a terminal resistor on the ‘OUT’ port of the transformer.
Use caution to not unintentionally connect a DMX wire to the Ethernet port or a powered Ethernet wire to a DMX port as damage can occur and
is not covered under the limited warranty.
Connectivity
Your Colorscaping transformer can be connected to the Internet using the W-Group Unified App available from the App Store or Google Play.
Follow the instructions in the app to connect the transformer to the network via either Wi-Fi (2.4GHz Only) or the onboard ethernet connection
in the transformer.
INSTALLATION INSTRUCTION
Colorscaping Transformer
8150CS-TRN-SS / 8300CS-TRN-SS
