WAC Lighting
www.waclighting.com
Phone (800) 526.2588 • Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone (516) 515.5000 • Fax (516) 515.5050
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone (800) 526.2588 • Fax (800) 526.2585
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. August, 2014
INSTALLATION INSTRUCTION
3.5” Shallow Recessed Housing and Trims
HR-3LED-H20A
LED AND DRIVER REPLACEMENT
1. Remove the trim or invisible trim
a. Remove the trim or invisible trim as shown below (See FIG.12 & 13).
To remove trim:
Remove the trim by pulling the trim’s edge
To remove invisible trim:
Remove the invisible trim by gently prying
between the invisible trim and lens
2. Replace LED
a. Disconnect wire connector, rotate the LED module counterclockwise and pull out to remove the
LED module from housing (See FIG.14).
b. Replace the LED by unscrewing the bracket, removing lens and reflector. Then, replace the LED (See FIG.15 & 16).
3. Replace Driver
a. Remove the LED module first (See step 2 and FIG.14), then, loosen wing nuts on the side of driver (See FIG.17).
b. Tilt driver downward and remove from housing (See FIG.18).
c. Remove screws to replace driver with new, rewire according to code and reinstall (See FIG.19).
Trim
Invisible Trim
LED Module
Wire
connector
Housing
LED
Reflector
Lens
Bracket
Screws
Connector
LED
Wing Nuts
Screws
