2
dweLED
retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
Jan 2019
dweLED
.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
S
486 - LED Outdoor
WS-W48612, WS-W48616, WS-W48620
FIG.1
Junction Box Screw
Mounting Screw
Rubber Gasket
Junction Box
Ground Wire
Mounting Back Plate
Wire Connector
Back Plate Dimensions
White Wire
Black Wire
B1
C1
D1
A1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
Junction Box
Caulking
Fig.3 Sealing
PREPARATION
1.
Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
2.
Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE
(Fig. 1)
3.
Remove the mounting screw (C1) and the rubber gasket (D1) from the mounting back plate.
4.
Secure the mounting back plate to the junction box using junction box screws (B1).
NOTE:
The side of the mounting back plate marked “GND” must face out.
CONNECTING THE WIRES
(Fig. 2)
5.
Connect the fixture’s wires to junction box wires as shown
(Fig. 2). Make
sure that all wire connectors (A1) are secure. If your outlet box
has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the
back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
COMPLETING THE INSTALLATION
(Fig. 1)
6.
Secure the fixture to the mounting back plate using the mounting screw (C1) and the rubber gasket (D1).
7.
To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline
the outside of fixture back plate where it meets the wall. Leave a space at the bottom to allow moisture to escape
(Fig. 3).
WS-W48612 5 3/4"
WS-W48616 7 5/8"
WS-W48620 9 1/4"
1 3/8"
1 3/4"
WS-W48612 4 1/8"
WS-W48616 5 1/8"
WS-W48620 5 5/8"
