WAC Lighting retains the right to modify the design of our products at any time as part of the company’s continuous improvement program. DEC 2018
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
2
INSTALLATION ACCESSORIES:
INSTALLATION WITHOUT AIMING BRACKET (FIG.3):
1. Place fixture at desired location within fountain, pond
or water feature.
2. Place rocks around fixture to keep it in place.
3. Route lead wire to 12V power source and make connection.
Use approved gel filled wire nuts.
4. Turn on 12V power supply and check for proper operation.
1. Place fixture at desired location within fountain, pond or
water feature.
2. Place rocks around fixture to keep it in place.
3. Route lead wire to 12V power source and make connection.
Use approved gel filled wire nuts.
4. Turn on 12V power supply and check for proper operation.
Outdoor Rated Wire Nut
Qty: 2pcs
Aiming Bracket Mounting
Screws and Anchors
Qty: 3pcs
Detachable Shroud
Qty: 1pc
FIG.3
Connect to 12V Transformer
Connect to 12V Transformer
Without Aiming Bracket
Factory Sealed
Liquid-tight Connector
With Aiming Bracket
Aiming Bracket
INSTALLATION WITH AIMING BRACKET (FIG.4):
1. Place fixture at desired location within fountain, pond or water
feature. Holes in bottom of aiming bracket can be used to attach
bracket to bottom/side surface if needed.
Using the holes on the aiming bracket to mark the three mounting
points. Using the marks to drill holes and insert the anchors. Mount
the fixture onto the anchors by using the mounting screws.
(Mounting screws and anchors are provided.)
2. Loosen thumb screws on both sides of the aiming bracket, adjust
fixture to desired angle then tighten thumb screws firmly.
3. Route lead wire to 12V power source and make connection.
Use approved gel filled wire nuts.
4. Turn on 12V power supply and check for proper operation.
5. To re-adjust fixture angle, turn off power and repeat Step 2.
FIG.4
Fixture With Aiming Bracket
Thumb Screw (on both sides)
Mounting Screws (Provided)
Screw Anchors (Provided)
Detachable Shroud
Hole Markings
X
X
X
INSTALLATION INSTRUCTIONS
Underwater Spot Light
5511
