IVTM
7
Workshop instructions
43
7.5
Replacing wheel module I with wheel module II
at the same time.
Always replace wheel module I with wheel module II.
Replace the rubber hoses with PA tubes
Vehicles with OE equipment
e notes of the manufacturer.
Rubber hoses can be fitted in vehicles installed with OE equipment. Before replac-
ing the hoses, observe the releas
The following table facilitates the replacement.
ebsite
htt
You will obtain further information on the use of wheel module II on our w
p://www.wabco-auto.com
=> WABCO online product database INFORM. Ente
search term "IV
r
the
TM" in the input field. Open the application table.
In this table, the rims are sorted according to their attachment location, size and
manufacturer. Next to an illustration of the respective installation situation, you will
also be provided with the product number of the wheel module and connecting
tube.
Wheel module I
Wheel module II
960 730 001 0(Independent wheel)
960 731 011 0
960 730 001 0 (twin tires, Super Single)
960 731 031 0
960 730 006 0 (Independent wheel)
960 731 021 0
960 730 06 0 (twin tires, Super Si
0
ngle)
960 731 041 0
960 730 013 0
960 731 061 0
960 730 037 0
960 731 019 0
7.6
Creeping pressur
re loss, first check the hose connec-
age indi-
– If these connections are tight, check bearing surface and edges.
dicators at the tire edges point on damages at the carcass, which
ses creeping pressure loss of the wheel.
e loss
– When the display hints to a creeping pressu
tion between valve and wheel module of the relevant wheel with leak
cating spray.
So-called in
usually cau
If the carcass is damaged, the tire must be replaced.
Summary of Contents for IVTM
Page 1: ...IVTM TIRE PRESSURE MONITORING FOR COMMERCIAL VEHICLES SYSTEM DESCRIPTION...
Page 2: ......
Page 47: ......
