11
Appendix IV
111
WABCO
Maintenance Manual MM-0112 (Revised 07-18)
When the replacement ECU is installed, the ABS lamp will be lit due
to an active DTC:
NOTE:
This DTC will clear after a configuration file has been
successfully loaded into the ECU. The ABS lamp will remain on until
the vehicle has been driven above 4 mph (
6
km/h).
Step 3: Acquire a configuration file from https://
wabco-na.snapon.com.
Configuration files are available for purchase at https://
wabco-na.snapon.com. Begin by either creating an account or
logging into an account created during a previous purchase from the
site. Figure 11.2.
NOTE:
If you purchased TOOLBOX™ Software, then you already
have an account, and that account information should be used to
log in.
Figure 11.2
Click the Aftermarket Programming Configuration Files button at the
top of the screen.
NOTE:
If TOOLBOX™ Software is not available at the point of
service, it can be purchased by clicking the TOOLBOX™ Software
button. Figure 11.3.
Figure 11.3
Enter the part details for the vehicle being worked on and the part
being replaced. Figure 11.4.
앫
The VIN must include all 17 characters.
앫
The part number of the ECU being replaced must be entered.
앫
The serial number of the ECU being replaced may be entered,
but is not required.
Figure 11.4
The next screen will show the details of the configuration file linked
to the part number and VIN combination entered. The price for the
configuration file will also be displayed. Verify the VIN, part number
and details of the ECU functionality match those of the ECU being
replaced. If this information is correct, click the Add to shopping cart
button. Figure 11.5.
SID
SPN
FMI
Description
253
6
30
2
Calibration Memory – Wheel
Parameter Incorrect
Figure 11.2
4012630
a
Figure 11.3
Figure 11.4
4012631
a
4012632
a
