W-Tec Pro 8, User Manual

Page: 10 / 19

10
•
Use and store it only according to the product requirements and within specified limits.
Otherwise you could damage the battery or shorten its lifespan. Improper using or storing may
result in warranty void.
BATTERY CHARGING
This product has an external charger. Connect the charging cable to the scooter charging socket
under the footboard on the rear right side. Then connect the charger into an electric outlet.
Red light
– battery is charged
Green light
– charging has been completed
WARNING:
•
Avoid long periods with fully charged or discharged battery.
•
Charge it fully for 9 hours to maximize its lifespan.
•
Before installing, maintaining or removing the battery, unplug the scooter from the outlet. It is
very dangerous to operate it in an unplugged state because of electric shock risk.
•
Don’t attempt to open the battery. Don’t insert any object into battery and don’t try to dismantle
with any tool to avoid electric shock, fire or injury. Pay attention. There are toxic substances
inside the battery.
•
Use only original charger. Dispose the battery only according to local laws and
environmentally friendly.
OPERATION
Power switch
There is ON/OFF button on the controller. Pressing the button by turn on the console. Pressing it
again will turn off the console.
WARNING: Release speed control before braking!
Speed control
Push the SPEED CONTROL to accelerate the E-Scooter.
Use the button on the display to switch between 3 modes to limit the maximum speed. When the
scooter is switched on, the last set mode is always active: slow 20 km / h; medium approx. 25 km / h
–
factory set maximum speed; fast approx. 35 km / h.