Controls Reprogramming
If you ever need or want to reset your controls to the
original factory setting for any reason press the two
buttons highlighted in green on the remote control as
shown below while at the same time pressing the small
button on the side of the control box. Do this until you
hear a beep. Your bed is ready to be used again.
Page 11
Control Box
Remote Control & Reprogramming
Model - SS3366
ZG Postition Button
Press and release to move the bed to
Zero-G position. Do
NOT
keep the
button pressed
Head & Foot Up
Press and hold to raise both the head &
foot sections up
Head & Foot Lower
Press and hold to lower the
head & foot section
Flat Button
Press and release to lower the bed to flat
position
Under Bed LED Light
Press to turn ON LED, press
again to turn OFF LED
Foot Massage ON
Press 1 time to turn ON foot massage
Press 2 times for second speed
Press 3 times for third speed (fastest)
Massage Modes
When massage is ON, press to switch
between pulse, wave and constant modes
Foot Up/Down
Press and hold to raise and lower
the foot section
Lounge Position Button
Press and release to move the
bed to Lounge position
TV Position Button
Press and release to move the
bed to TV position
M1 and M2 Buttons
Press and release M1 and M2 buttons
to recall positions. Press and hold 5
secs to save new positions
Head Massage ON
Press 1 time to turn ON head massage
Press 2 times for second speed
Press 3 times for third speed (fastest)
Massage
Timer/All OFF
P
ress 1 time for 10 minute timer
Press 2 times for 20 minute timer
Press 3 times for 30 minute time
During operation, press to turn OFF
Remote Flash Light
Press and hold to turn ON the flash
light located on the remote control,
release the button to turn it OFF
Head Up/Down Button
Press and hold to raise or
lower the head section
Massage Timer Light
10 MIN = 10 minutes selected
20 MIN = 20 minutes selected
10 & 20 MIN = 30 minutes selected
