Start Up
This speaker system is to be directly connected to the outputs of your audio mixer or keyboard
etc.
Roll the subwoofer to the desired installation area and carefully turn it onto its feet.
Make sure that the power switch is set to “OFF” before you connect the speakers.
Inputs
A good quality cable run improves the sound quality considerably. Input cables should be short
and direct, since high frequencies may be absorbed if the cables are unnecessarily long. Also a
longer cable may lead to humming and noise problems. If long cables runs are unavoidable, you
should use balanced cables.
In order to obtain the highest sound quality, only use high quality cables for connecting the units.
The Gig Rig 2 can be connected via balanced jack plugs or XLR plugs.
Always connect the left and right channels for stereo operation. For mono operation, connect the
mono signal to the left input. Connect the left output socket via a cable to the right input.
Balanced XLR Connection
9
Connection With The Mains
Connect the unit to the mains with the power plug.
The earth has to be connected.
Switch the unit on. After switching on the speaker system, wait 8 - 10 seconds before you turn the
volume control up in order to avoid speaker damage.
CAUTION!
Increase the level of each channel up to the point where the clip LEDs illuminate.
Always check the sound pressure level with a meter in order to keep to the legal threshold.
