Rack Installation
The EP Series is built for 19” racks (483mm). The rack you use should be a Double Door Rack
where you can open the front and rear panel. When mounting the amplifier into the rack, please
make sure that there is enough space around the amplifier.
Be careful when mounting the amplifier into the rack. Put the heaviest products into the lower part of
the rack. Be aware that fastening the amplifier with four screws on the front panel is not enough.
If the racks are being transported or used for mobile use, additionally fasten the products by
connecting the rear brackets with the side or ground bars of the rack. In this way, the amplifier
cannot be pushed backwards. The front panel is not designed to absorb acceleration forces
occuring during transportation.
Inputs
Short cables runs improve the sound quality remarkably. Input cables should be short and direct,
since high frequencies will mostly be absorbed if the cables are unnecessarily long. Besides that
a longer cable may lead to humming and noise problems. If the cable runs are unavoidable, you
should use balanced cables.
Outputs
The high damping factor of your amplifier supplies a clear sound reproduction.
Unnecessarily long and thin cables will influence the damping factor and thus the low frequencies in
a negative way. In order to safeguard good sound quality, the damping factor should lie around 50.
The longer a cable has to be the thicker it should be.
Connect your speaker systems via the speakon plugs or thr Bannana/Screw combination (red+,
black-)
Switch
Adjustments
Ground Lift Switch
- This switch allows the signal ground or chassis ground to be separated
in case of a ground conflict. For highest safety of the equipment, it is recommended to keep the
Ground Lift Switch in the GND FLOATING position. In case of a ground conflict please set the
ground lift switch to GND LIFT.
Connection
To
The
Mains
Connect the amplifier only after having made sure that the right voltage (240V) is supplied and that
the ground lead is earthed. This product falls under Class 1. Do not detach the ground lead.
5
