www.prolight.co.uk
DSR Series Active Speakers
User Manual
7
Start Up
Place the speaker to the desired installation area and carefully turn it onto its feet.
Make sure that the power switch is set to “OFF” before you connect any audio cables.
Inputs
This speaker system is to be directly connected to the outputs of your audio mixer or keyboard etc.
A good quality cable run improves the sound quality considerably. Input cables should be short and
direct, since high frequencies may be absorbed if the cables are unnecessarily long. Also a longer
cable may lead to humming and noise problems. If long cables runs are unavoidable, you should
use balanced cables.
Connection
•
Before connecting the speakers and audio source to this device, make sure that all volume/gain
controls are turned fully anti-clockwise in the minimum position.
•
Turn on the mains power switch and the mains LED will illuminate.
•
IMPORTANT! DO NOT OVERDRIVE THE SYSTEM.
If any distortion or clipping is audible you must reduce
the input signal level or reduce the volume of the satellite speakers and bass. Failure to do so will
cause damage to the amplifier and or speakers.
Operating instructions & example setups