Vytronix JETW1800, Instruction Manual

Page: 10 / 12

8
Symptom Cause Recommended action
The machine will not
start
The machine is not plugged-in Plug the machine in
The fuse has blown Replace the fuse Unplug other appliances
Faulty extension cable Try without the extension cable
Fluctuating pressure The pump is drawing in air Check that hoses and connections are airtight.
Valves dirty, worn or sticking Contact Vytronix Ltd
The water supply is not
sufficient
Increase water pressure, check for blockages
and / or change the large pipe.
Pump seals worn Contact Vytronix Ltd
The machine stops The fuse has blown Replace the fuse
Incorrect mains voltage Unplug other appliances
Check that the mains voltage corresponds to the
specifications on the rating label.
Thermal sensor activated Leave the machine to cool for 5 minutes
Partially blocked jet Clean the jet with a needle and by spraying
water rearwardly through the jet
Fuse blown Fuse too small Replace it with a fuse with higher amp
consumption than the washer.
Increase in the amperage Try without the extension cable
Pulsing machine Air in inlet hose / pump Allow machine to run with open trigger until
regular working pressure resumes.
Inadequate supply of water
generated
Increase water pressure, check for blockages
and / or change the large pipe.
Partially blocked jet Clean the jet with a needle and by spraying
water rearwardly through the jet
Water filter blocked Clean the filter
Folded pipe Unfold the pipe
The machine turns on
and off by itself
Pump fuse and/or trigger not
working correctly
Contact Vytronix Ltd
No water supply Connect the inflow water.
The machine is on
but no water comes
out
Water filter blocked Clean the filter
Blocked jet Clean the jet with a needle and by spraying
water rearwardly through the jet
Troubleshooting