- 7 -
CHANGING THE DUST BAG
If the vacuum
’s suction is reduced, this may be because the bag needs
changing. Keep an eye on the bag change indicator. If it is red, the bag
must be changed prior to further use.
1. Turn off and unplug the vacuum cleaner.
2. Remove the hose, open bag cover by pushing
latch up and lifting cover.
3. Grasp the rigid section at the top of the dust bag and
carefully remove the bag from the vacuum cleaner.
4. Dispose of the full bag. Make sure that there are no holes in it.
5. Insert a new dust bag in the vacuum cleaner.
The vacuum cleaner must never be used without a dust bag.
6. Close the vacuum cleaner again.
7. Try to avoid vacuuming up large quantities of fine material such as
sand or flour and replace the bag immediately if you do so.
Cleaning the motor filter
1. The motor filter can be found in the dust bag container.
It protects the motor from dust and should be cleaned
regularly to avoid loss of suction / decreased performance.
2. Pull the filter holder up out of the vacuum cleaner
3. Open the filter holder and remove the filter.
4. Rinse the filter in warm but not hot water and allow it to dry
completely before placing back in the vacuum.
Do not use a hair dryer or similar to dry the filter.
5. Return the filter to the holder and replace the filter holder in
the vacuum cleaner.
IMPORTANT!
Never use the vacuum cleaner without a motor filter.
TRANSPORT AND STORAGE
1. You can lift and carry the vacuum cleaner using the carrying handle. Never lift the vacuum cleaner by the
power cord or hose.
2. Before putting the vacuum away, switch off the socket, unplug, and press the cord rewind button whilst
holding the plug until the cord is fully rewound.
3. To save space, the vacuum can be stored upright on its end cover. The extension tube can be hung on the
vacuum cleaner by inserting the parking fixture on the floor head into the vertical parking holder on the
body of the vacuum cleaner.
