REPLACEMENT PARTS
May 2, 2011
Non-replaceable Parts
|
JACE-700 MOUNTING AND WIRING GUIDE
Part Number 11694 Rev 1.6
31
Replacement Parts
Servicing the JACE-700 controller may call for replacement parts. There are three
categories of parts:
•
•
•
Non-replaceable Parts
The controller contains a non-user replaceable 2.5A slow-blow fuse, soldered on the
main circuit board. This fuse provides protection from internal shorts or connection
to incorrect power supplies. If the fuse circuitry is suspect, contact technical
support. See the
Standard Replacement Parts
Standard replacement parts are listed in
, and can be ordered from stock
without restriction. Standard replacement parts cannot be returned for credit and
should be disposed of in an appropriate manner.
New Replacement Unit
To replace an entire unit, order and install a
new
JACE-700 controller. If the faulty
controller is
still in warranty
, you can receive credit by returning it. Be sure to
contact the vendor for a return authorization (RA) number before shipping an item
for return credit. See
page 33, for more details.
Note
Before ordering a new controller, it is strongly recommended that you
contact your normal technical support resource to eliminate the possibility
of a software issue or mis-configuration problem.
Table 5
Standard replacement parts for a JACE-700 controller.
Part Number
Description
NPB-J700-BATT
NiMH Battery Pack—see
“Required NiMH Battery Maintenance,”
J7-1GB
1 GB DDR-2 333MHz SODIMM RAM memory module (replacement part)
11696
Hardware Bag for JACE-700, containing screw terminal connector plugs (two
6-position, one 2-position, earth grounding wire).
