VWR International MU 6100 H, Instruction Manual

Page: 63 / 96

MU 6100 H Settings
ba77077e02 09/2014
63
10.2.2 Data storage
This menu contains all functions to display, edit and erase stored measured
values and calibration records (see section 11 D
ATA MEMORY
, page 66).
10.2.3 Automatic Stability control
The automatic Stability control (AutoRead) function continuously checks the
stability of the measurement signal. The stability has a considerable impact on
the reproducibility of measured values.
You can activate or switch off the automatic Stability control function (see sec-
tion
10.2.1 S
YSTEM
,
page 62).
The measured parameter flashes on the display

as soon as the measured value is outside the stability range

when the automatic Stability control is switched off.
10.3 Reset
You can reset (initialize) all sensor settings and sensor-independent settings
separately from each other.
10.3.1 Resetting the measurement settings
The following settings for pH measurements are reset to the default settings
System / Clock Date format
Datum
Time Time and date settings (see
section 5.4.6 E
XAMPLE
2
ON
NAVIGATION
: S
ETTING THE DATE
AND TIME
, page 24)
System / Service infor-
mation
Hardware version and software
version of the meter are dis-
played.
System / Reset - Resets the system settings to
the delivery condition (see sec-
tion 10.3.2 R
ESETTING THE SYS
-
TEM SETTINGS
, page 65).
The calibration data are reset to the default settings together with
the measuring parameters. Recalibrate after performing a reset.
Menu item Possible
setting Explanation