3
1
2
3
6
5
4
7
8
9
M
ANUFACTURED BY
:
201 Wolf Drive • PO Box 87 • Thorofare, NJ 08086-0087
Phone: 856-686-1600 • Fax: 856-686-1601 • E-mail: [email protected]
www.troemner.com
540001-00 (REV 2 - 9/10)
HENRY TROEMNER LLC
H
EATING
O
PERATING
I
NSTRUCTIONS
1.
Get ready:
Turn heat knob to the off position, at the extreme counter-clockwise position. Plug
power cord into a standard 3-prong grounded outlet. Place a vessel with the
solution and the appropriate accessories in the center of the top plate. This is
important because the vessel should be over the hottest part of the top plate.
2.
Set temperature:
Turn the heat knob clockwise until the pointer reaches the selected heat setting.
As soon as this is done, the red pilot light will flash on and will stay illuminated
until the hotplate reaches the selected temperature setting (graduations on the
panel surrounding the control knob are reference marks only and do not indicate
specific temperatures). The pilot light will continue to light intermittently as the
thermostat acts to maintain this temperature. Rotating the heat control to its full
on position will bring the hotplate surface to its maximum temperature of about
400°C. After cycling for a short period, the plate temperature should stabilize
between 350°C and 400°C, when the control setting is left on "HIGH". To prevent
possible damage, however, this position should not be maintained indefinitely.
DO
NOT
allow the unit to operate at maximum temperature without a beaker or flask
(with fluid) on the top plate.
3.
Adjust temperature:
Temperature adjustments can be made without interrupting heating by turning the
indicator knob clockwise to increase heat, or counter-clockwise to decrease heat.
4.
Stop:
To stop heating, turn the heat knob to the extreme counter-clockwise position.
Your vessel can then be removed. The heating knob should be kept in the off posi-
tion when not in use.
D
ESCRIPTION
P
ART
N
UMBER
1. Top plate
242040-00
2. Heater
342008-00
(heating models only)
3. Thermostat
342011-00
4. Heat knob
242016-00
5. Stir knob
242017-00
6. Speed control
342007-00
7. Magnet assembly
486002-00
(stirring models only)
8. Motor
386027-00
9. Feet
530052-00
10. Power cord
330067-00
R
EPLACEMENT
P
ARTS
10
