USE INSTRUCTIONS
Up & Down Movement:
Press the UP arrow continuously, the legs will move up
Press the DOWN arrow continuously, the legs will move down
Release arrows to stop movement.
Memory Preset Positions:
Use the UP and DOWN arrows to set table at a desired height.
Press the POSITION SETTING BUTTON (S) followed by one of the 4 PRESET POSITION
BUTTONS(1 2 3 4) buttons. The memory position is set.
There are up to 4 presets available. To return to a memory preset press the desired number.
Reset:
Press the DOWN button and lower the desk to its lowest setting..
Press the DOWN Button again for ~ 5 seconds until the LED reads “RST”
Press the DOWN button & hold it while the legs move up & down to level and stop.
Release the DOWN button as the control box a “Bi--” sound,the reset is now complete
and your table is ready to use.
Page7
Child lock
Press the up arrow and down arrow at the same time for 5 seconds, and then release
the sound when the control box makes a “Bi--” sound.The handset displays “---” and
the table enter the Child lock mode.
Unlock
Press the up arrow and down arrow at the same time for 5 seconds, and then release the
sound when the control box makes a “Bi--” sound. The handset displays the number and
the table exit the lock mode.
Page 7
Slide the two (2) Crossbar center Rails (Part #1)
into the two Crossbar Ends, (Part #2)
ensuring:
a) the slots Face inward
b) the slot is closer to top edge of the
Crossbar center Rail (Part #1) when
the assembly is upside down (see inset)
For each leg, a
�
ach a foot (Part #5) with
four (4) M6x12 Machine Screws (Part #7 )
and
�g
hten screws in a cross pa
�
ern.
Check both sides of the desktop before placing
your desk base on the underside of the desktop.
Your desktop may or may not be pre-drilled.
Adjust the width of the desk base to
fi
t the
desktop by sliding the two halves outward.
We recommend leaving at least-3cm of the desktop
width (on each end) protruding beyond the
frame width and centered to the base
Lock the pos
i�o
n of the Crossbar center Rails (Part #1
）
using eight (8) M6x10 Machine Screws (Part #8 ).
Remember,maximum width is 180cm.
Ensure that the M6x10 Machine Screws (Part #8 ) contacts the A center Rails (Part #1)
by sliding the center Rails (Part #1) as needed.
ASSEMBLY INSTRUCTIONS
STEP4
STEP5
STEP6
STEP7
Page 4
www.vwindesk.com
www.vwindesk.com
