vwin VJ201-S2, Assembly And Operation Instructions Manual, Page: 11 / 11

Error code Instructions How to do?
E01 Main power is to high Check the main power
E02 Screw clearance over 1cm Initialization
E03 Hand Controller no connect Waiting for the system sleep
E04 Hand Controller communication error Check hand controller line
E05 Blocked off Stop Loosen the button Rerun the
E06 Main power start error Change controller box
E07 Main power run protect Reconnect controller power
E08 The table tilt when it is running Initialization
E09 Main power High temperature protect Wait temperature down
E11 Motor1 no connect Check motor line
E12 Motor1 Current sampling error Change controller box
E13 Motor1 lose phase line Check motor line
E14 Motor1 Hall error Check the hall or hall line
E15 Motor1 phase short Change motor
E16 Motor1 blocked Initialization
E17 Motor1 direction error Lines to change the motor or hall
E18 Motor1 over load Reduce the load
E21 Motor2 no connect Check motor line
E22 Motor2 Current sampling error Change controller box
E23 Motor2 lose phase line Check motor line
E24 Motor2 Hall error Check the hall or hall line
E25 Motor2 phase short Change motor
E26 Motor2 blocked Initialization
E27 Motor2 direction error Lines to change the motor or hall
E28 Motor2 over load Reduce the load
E40 Tandem line drops Check the tandem line
E41 Tandem signal error Check the tandem line or change
box
E42 EEPROM error change box
E43 Gyro-sensor error change box