VuQube VQ1, Operating Instruction

Page: 13 / 24

Page 11
DRAFT 05-20-10
Dish HD Alternate with Locals
DISH 500
MUST SHOW
“SW21”
NO “X”s
DISH HD Western Arc with Locals
MUST SHOW
“SW64”
NO “X”s
If indicated results are not obtained, run test again. Contact King Controls if the check switch
fails to load after 4 attempts.
6. Save the settings, exit to the main menu screen and wait for programming to download.
7. DISH HD Alternate with Locals and Western Arc with Locals only: Verify your saved
settings show your desired satellite trio 61.5, 110, 119, or 110, 119, 129.
Automatic satellite switching is now active. The antenna will switch to the appropriate
satellite based on the channel you select using the receiver’s remote control. Enjoy!
Note: To exit automatic switching mode (for example, you have moved and need to re-acquire the satellites using
Normal Operating Mode), follow steps 1-4 on page 10. Make sure the “x” lights up when Mode 01 is displayed.
You will not have to rerun the check switch when re-entering automatic mode after re-acquiring the satellites
(see gray box on page 10 for exceptions).
5. Run the check switch again (steps 3-6 on page 7). DO NOT DISCONNECTTHE COAX.
When test is complete, a screen similar to one below should appear.
(Receivers are always changing, and therefore screen graphics may vary.)