GRA SERIES GAS FRYERS - REMOVAL AND REPLACEMENT OF PARTS
5.
Reverse procedure to install and check for
proper operation.
FILL SOLENOID VALVE
(KLEENSCREEN FRYERS ONLY)
1.
Open the fryer section doors above filter pan.
2.
Pull filter drawer out, remove filter tank
assembly and push the tank support arms back
into place under the fryer.
3.
Remove splash guard.
4.
Disconnect swivel pipe fitting at rear of fry tank.
5.
Disconnect fill solenoid valve lead wire
connector (4 pin) from power supply box.
6.
Remove screws (2) securing the solenoid valve
body flange to pipe tee then remove the
assembly from fryer.
A.
Remove pipe fittings from solenoid valve
and install on replacement valve.
7.
Reverse procedure to install and check for
proper operation.
PUMP AND MOTOR
(KLEENSCREEN FRYERS ONLY)
1.
Drain filter tank of shortening.
REAR VIEW SHOWN
F25377 (March 2010)
Page 11 of 36
