VTS Medical Systems WING C100-200, Technical Documentation Manual

Page: 5 / 23

5
The range of the air jet - installation height
- Horizontal installation - Vertical installation
CAUTION!
Air curtains with electric heat (models E100, E150 and E200) are not intended for vertical installation.
IMPORTANT!
The heating output should be adjusted to the temperature inside the room, as well as the strength and direction of the wind outside. The primary criterion for the regulation of the
heating power is the temperature inside the room, near the door. Should a room thermostat be used, WING activates the heating mode, depending on the temperature settings.
IMPORTANT! Please consider additional factors that affect device operation.
Factors that have a negative effect on curtain operation Factors that have a positive effect on curtain operation
doors or windows that are constantly open in the room, thus creating a draft presence of awning, roofs etc. on the outer side of the door
constant and open access to staircases, available through the room, the chimney draft
effect
use of revolving doors
3.1. ASSEMBLY/ DISASSEMBLY OF JUNCTION BOX COVER
To access the terminal block remove the screws from the junction box cover and tilt it .
3.2. INSTALLATION OF DEVICE
For directly installation use the threaded slee ves (5/16” ) in the top of the device.
5/16”
IMPORTANT! The minimum distance between the unit and the ceiling should be 4 in.
fan speed III II I
height of installation [ft]
H3 H2 H1
WING W100, W150, W200 12 9-1/2 7-1/2
WING E100, E150, E200 12 9-1/2 7-1/2
WING C100, C150, C200 13 9-1/2 7-1/2
fan speed III II I
width of the door [ft]
H3 H2 H1
WING W100, W150, W200 12 9-1/2 7-1/2
WING C100, C150, C200 13 9-1/2 7-1/2
EN