VTR EFFECTS – DREAM MACHINE V2 Page 5
Access Presets
Send a Program Change message with the preset number you want to access
(Example: Preset 1 = 10; Preset 2 = 20).
Save Presets
Hold the footswitch Bypass and send a Program Change message with the
preset number you want to save, the pedal will save the current setting in
the desired location (12 slots available).
Control Parameters
Send a Continuous Controller message according to the information below:
CC #1
- Effect ON/OFF (Value 127 = ON / Value 0 = OFF)
CC #2
- Delay Modes:
Value 1 = Digital;
Value 2 = Analog;
Value 3 = Tape;
Value 4 = Overnotes;
Value 5 = PitchShift;
Value 6 = Lo-Fi.
CC #3
- Mix (Send a value from 0 to 127)
CC #4
- Dream (Send a value from 0 to 127)
CC #5
- Emotion (Send a value from 0 to 127)
CC #6
- Repeat (Send a value from 0 to 127)
CC #7
- Tap Switch (You can send any value with this CC#, it will simulate
tapping the tap switch. It's a way to set the tap tempo via MIDI.)
OPERATION
TrueBypass or TailsBypass:
When turning on the pedal power, the bypass led
will flash green to indicate true bypass and red to indicate Tails bypass, to
change the bypass type, hold the bypass switch while turning on the power on
the pedal.
Intelligent Bypass:
The Dream Machine V2 is equipped with an intelligent
bypass system, which will recognize the time of pressing the footswitch and
automatically activate the momentary bypass function. Therefore, pressing the
footswitch quickly will do the normal function of reversing the bypass state,
pressing and holding the footswitch for more than 500ms when releasing the
bypass will return to the state before it was pressed, performing the
momentary bypass function.
Change Delay Mode:
Press both footswitches at the same time.
Change MIDI channel:
When turning on the pedal power, keep the preset
footswitch pressed and the Preset LED will light up, turn the Time knob and the
LED color will change, thus indicating the channel change, as follows: Blue:
Channel 1; Green: Channel 2; Red: Channel 3; White: Channel 4.
LED GUIDE
Bypass LED:
When lit indicates the effect is on and its color indicates which
preset is selected.
Green
: Bank 1;
Red
: Bank 2.
Preset LED:
Its color indicates which preset is selected along with the bypass led
color.
Green
: Preset 1;
Blue
: Preset 2;
Red
: Preset 3;
White
: Preset 4.
Change Delay Mode:
Press both footswitches at the same time.
