VTech vt9113, Operation Manual

Page: 4 / 16

4
Setting Up Your VT9113
1. Choose an area near an electrical outlet and a telephone wall jack.
2. Plug the AC power adapter into an electrical outlet and the DC connector to the power
jack on the bottom of the Base Unit. Insert the cord in the channel guide.
CAUTION: Use only the AC adapter shipped with your VT9113. It is specifically designed
for this product.
NOTE: Connect power to the Base Unit before placing the handset in the cradle.
3. CHARGE THE HANDSET BATTERY PACK BEFORE USE. The batteries recharge
automatically whenever the Handset is in the Base Unit cradle. The batteries must
be charged for 16 hours before using your phone for the first time.
4. Connect the telephone line cord. Insert one end of the telephone line cord into the
phone jack on the bottom of the Base Unit. Plug the other end into a telephone wall
jack. Make sure the plugs snap securely into place. Insert the cord in the channel
guide.
5. CHECK FOR A DIAL TONE. After the battery pack is charged, pick up the Handset
and press the ON key. The IN USE LED on the Base and ON LED on the Handset
should light up, and you should hear a dial tone. If not, see IN CASE OF DIFFICULTY.
CAUTION:
1. Never install telephone wiring during a lightning storm.
2. Never install telephone jacks in wet locations unless the jack is specifically designed
for wet locations.
3. Never touch uninsulated telephone wires or terminals unless the telephone line has
been disconnected at the network interface.
4. Use caution when installing or modifying telephone lines.
GETTING STARTED