3
Before You Install
1. Choose a location for the Base near an electrical outlet and a telephone jack.
This phone requires a modular telephone jack and a standard electrical outlet (110v AC)
not controlled by a wall switch. Plug the AC power adaptor into the electrical outlet and
the DC connector to the jack on the bottom of the Base Unit.
2. Install the Handset battery pack. Use only battery pack provided or recommended by
the manufacturer.
NOTE: Install the Base Unit away from electronic equipment, such as personal
computers, television sets or microwave ovens. Avoid excessive heat, cold, dust or
moisture.
INSTALLATION
a) Remove battery
compartment cover by
pressing on the indenlation
and siiding downward.
b) Align the two holes in the plug
with the socket pins, then snap
the plug into place.
c) Place battery pack in the
compartment with the wires
in the lower left corner. Run
the wires under the guide
located directly below the
battery pack.
d) Replace cover by sliding
it up into place.
Summary of Contents for vt2423
Page 1: ......
