![VTech VM5251 Quick Start Manual Download Page 2](http://html.mh-extra.com/html/vtech/vm5251/vm5251_quick-start-manual_1053375002.webp)
Specifications are subject to change without notice.
© 2017 VTech Technologies Canada Ltd. All rights reserved.
11/17. VM5251_CA_QSG_V1.
Document order number: 96-012028-010-100
Basic operation -
Parent unit
Adjust speaker volume
Press
or
to adjust your parent unit
speaker volume. It determines the volume of sound
transmitted from your baby unit.
Zoom
Press to zoom in or out.
Overview -
Parent unit
Overview -
Baby unit
Turn off the parent unit
Press and hold
POWER
to power off your parent unit.
Use the menu
Press
MENU/SELECT
to enter the menu, choose
a menu item, or save a setting. You can use
the parent unit menu for the advanced settings
or operations, such as to play or stop the baby
unit lullaby, or to adjust the baby unit sound
sensitivity.
While in the menu:
Press or to scroll up or down.
Press to select an item.
Press to return to the main menu or idle
screen.
•
•
•
Talk to your baby unit
Press and hold
TALK
and speak to your parent unit.
Your voice is transmitted to the baby unit.
Turn off the screen
Press and hold
LCD ON/OFF
to switch off the
screen. You can still hear sound from the baby
unit.
Press any keys on the parent unit to turn on the
screen again.
•
LCD is turning off...
TIP
Alert Tone
Low Battery Tone
No Link Alert
Sound alert in split-view
POWER
TALK
Zoom
Microphone
LED lights
Arrow keys
MENU / SELECT
Volume
VIEW / LCD ON/OFF
Antenna
Stand
Power jack
Speaker
Battery compartment
cover
6U]KXOTMULL
6U]KXOTMULL
ē
63
ē
ē
63
ē
63
ē
Press and hold
63
ē
63
ē
63
ē
Camera
Light sensor
Infrared LEDs
Microphone
ON/OFF
LED light
ON/OFF
switch
Temperature
sensor
Speaker
Wall mount
holes for upright
mounting
Wall mount holes
for lateral mounting
Long press
Long press
Mount the baby unit (optional)
Drill two holes in the wall.
If you drill the holes into a stud, go to
step 3.
-OR-
If you drill the holes into an object other
than a stud, insert the wall anchors into
the holes. Tap gently on the ends with a
hammer until the wall anchors are flush
with the wall.
Use a pencil to mark two holes in parallel.
Make sure they are the same distance
apart as the wall mount holes on the baby
unit.
NOTES
Check for reception strength and camera
angle before drilling the holes.
•
Depending on your preference, choose the upright or lateral orientation to
mount your unit. Align the wall mount holes at the bottom or at the rear side
of the baby unit with the screws on the wall. Slide the baby unit down until it
locks into place.
OR
Insert the screws into the holes and tighten
the screws until only 1/4 inch of the screws
are exposed.
Tilt or rotate to adjust camera angle.
OR
You will need to purchase the
following items separately to mount
your baby unit:
2 screws
2 anchors