8
Getting Started
Before You Install
1. Choose a location for the base near an electrical outlet and a telephone
jack. This phone requires a modular telephone jack and a standard electri-
cal outlet (110v AC) not controlled by a wall switch.
2. Install the handset battery. Use only VTech batteries.
Installation
a ) . Remove battery
c o m p a r t m e n t
cover by pressing
on the indentation
and sliding down-
wards.
b). Align the two holes in the plug with the
socket pins, then snap the plug into place.
c). Place the battery in the compartment with
the wires in the lower right corner. Angle
the top of the battery under the top claws
first, then snap the bottom of the pack in.
Place the wires under the guide, located
below the battery.
d) Replace battery compartment cover.
3. Plug the DC connectors to the base and charger separately. Plug the AC
adaptors into electrical outlets separately. Connect the telephone line cord
to the jack on the base, and the other end to a modular telephone jack, as
illustrated below.
4. Place the handset in the base or charger. Charge the battery at least 15 hours
for first charging.
2450a.pmd
12/23/2004, 4:22 PM
8
