4
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned
Off
.
2. Find the battery cover located
on the back of the unit, use a
screwdriver to loosen the screw,
and then open the battery cover.
3. Remove old batteries by pulling
up on one end of each battery.
4. Install 1 new AAA (LR03/AM-4) battery following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the screw to secure.
Note:
If there is no response when the scorpion is switched on,
please install brand new batteries and try switching the scorpion
on again.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.
