4. Enter Registration Mode :
To work as the handset extension, the Pendant must be registered to the base.
1. Press and hold <PAGE> on the base station, until you hear a beep and the IN USE LED on base station starts
to flash.
2. Press and hold <VOL+> together with <VOL -> until the LED on wireless headset toggling between red and blue.
3. Place the Pendant unit close to the Base.
4. A long beep tone is generated and the LED on in blue for a while if the registration is successful.
Note: To register the Pendant unit, the system PIN of the Dect phone base should be 0000. Or else, the
registration will be failed.
Remark : It will hear the voice message in below 3 events :
1. Battery
low
2. Out of range
3. Not
Registered
4. Use the P
endant
:
To receive a call with the P
endant
:
Press the Phone on key when receiving a call with ringer on.
Talk to the caller with the PENDANT about 1 foot from your mouth.
After the caller release the line, press the Phone on key to standby mode.
To dial the M1 or M2 numbers stored in the Dect phone :
You can press the M1 or M2 key to dial the phone number which is stored in the M1 or M2 of the Dect phone.
Remarks :
1. Fine tune the speaker sound level refer to the incoming level and your hearing sensitivity, especially for elder
person.
2. The microphone is on the top left side. Do not cover it by your finger when in talk mode
3. Place the unit on the charger bay after use it to make sure the battery power is full.
4. If the unit is not working even the battery is charged, use a pin to reset the unit (there is the reset hole on the
rear side under the VOL - key.
Technical Specifications :
RF frequency band
1921.536MHz – 1928.448MHz
Channels 5
Operating temperature
32 deg F – 113 deg F
0 deg C – 45 deg C
Nominal effective range
250m outdoor
DC adaptor output
DC 6V @ 400mA
Operating times*
Talk time : up to seven hours
Standby : up to seven days
*Operating time varies depending on your actual use and the age of battery.
