5
GETTING STARTED
Battery Removal and Installation
1.
Make sure that the unicorn is turned
Off.
2. Locate the battery cover on the bottom of the unicorn.
Use a screwdriver to loosen the screw and remove the
cover.
3.
If used batteries are present, remove these batteries
from the unit by pulling up on one end of each battery.
4. Install 4 new AA (LR6/AM-3) batteries following the
diagram inside the battery box. For best performance,
alkaline batteries or fully charged Ni-MH rechargeable
batteries are recommended.
5. Replace the battery cover and tighten the screw to
secure.
WARNING:
Adult assembly required for battery installation. Keep batteries out
of reach of children.
IMPORTANT: BATTERY INFORMATION
•
Insert batteries with the correct polarity (+ and -).
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
•
Only batteries of the same or equivalent type as recommended
are to be used.
•
Do not short-circuit the supply terminals.
•
Remove batteries during long periods of non-use.
•
Remove exhausted batteries from the toy.
•
Dispose of batteries safely. Do not dispose of batteries in fire.
Rotate the packaging lock 90 degrees
anticlockwise.
Pull out the packaging lock and
discard.
