Appendix
15
California Energy Commission battery charging testing instructions
This telephone is set up to comply with the energy-conserving standards right out of the box. These
instructions are intended for California Energy Commission (CEC) compliance testing only. When the
CEC battery charging testing mode is activated, all telephone functions, except battery charging, will be
disabled.
To activate the CEC battery charging testing mode:
Unplug the telephone base power adapter from the power outlet. Make sure all handsets are
plugged with charged batteries before proceeding.
While you press and hold
/FIND HANDSET, plug the telephone base power adapter back to the
power outlet.
After about 20 seconds, when the
IN USE light starts flashing, release /FIND HANDSET and
then press it again within 2 seconds.
When the phone successfully enters the CEC battery charging testing mode, the
IN USE light
turns off and all handsets display
Put HS on BASE to register.
When the phone fails to enter this mode, repeat Step 1 through Step 3 above.
Note: The telephone base will be powered up as normal if you fail to press /FIND HANDSET within
2 seconds in Step 3.
To deactivate the CEC battery charging testing mode:
Unplug the telephone base power adapter from the power outlet, then plug it back in.
Then the telephone base is powered up as normal.
Register your handsets back to the telephone base. See page 4 for handset registration
instructions.
1.
2.
3.
1.
2.
