12
12
12
GETTING STARTED
When you use the
KidiZoom
®
PrintCam
camera for the first time, switch the
Master Power Switch
to the
position.
When the
Master Power Switch
is in the
position, it is not possible to charge
the camera or play any activities, and the system clock will reset.
Battery Charging
Note:
Adult operation required.
•
Make sure the camera is not in use and the
Master Power Switch
is in the
position. Pull up the rubber cover that is over the
Micro-
USB Port
on the side of the camera.
•
Insert the
Micro-USB Cable
(small end) into the
Micro-USB Port
on the camera.
•
Insert the large end of the
Micro-USB Cable
into a USB port on a
computer.
•
When the battery is charging, a red LED will
illuminate and you will see the battery charging icon.
•
When the battery is fully charged, the LED will turn
green and the screen will turn off. Disconnect the
camera from the power source.
Charging Guidelines
Only charge this device using the included
Micro-USB Cable
connected to a computer. Do not charge using a third party adaptor.
Before use, inspect the cord to confirm that it is in good condition
and that there are no breaks or exposed wires. Ensure there are no
particles or liquid (water, juice, etc.) in either of the connectors before
plugging in either end of the cable. The device should be completely
dry with no debris in the cable connectors when charging. Plug in
the cable securely, in the correct orientation. If the device is on when
plugged in, a dialog box may open on your computer to allow you to
access the device’s drive. Never leave the device unattended while
charging. Do not charge your device on soft surfaces, as they can trap
heat around the device. Typical charging time is between four to seven