9
Water Tank
1. Attach the
SmartPoint
™ water tank exit ramp and the ramp to the
water tank.
2. Attach the water tank gate to the water tank.
3. Attach the fully assembled water tank to the rocky path spiral ramp
as shown.
After the above steps, connect these pieces to the included track pieces.
You can configure them into different arrangements.
GETTING STARTED
BATTERY INSTALLATION - Rhino
1. Make sure the unit is turned
OFF
.
2. Locate the battery cover on the bottom of
the rhino. Use a coin or a screwdriver to
loosen the screw.
3. Install 2 new ‘AAA’ (AM-4/LR03) batteries following the diagram
inside the battery box. (The use of new alkaline batteries is
recommended for maximum performance.)
4. Replace the battery cover and tighten the screw to secure the battery
cover.
Assembly Instructions / Getting St
ar
ted
